25mm T Connector

25 mm T Connector to Create Safe Bifurcations in the Water System

If you want to set up a safe watering system with high pressure without any leaks, the best type of piping you can use is 25 mm.

Diversify your tubes to supply water to the grow but avoiding flooding or water wastes 

These 25 mm T connectors allow you to turn your main pipe line into two different branches, allowing you to water up to four rows of plants. All pieces are threaded, which decreases the risk of leakage considerably.

No more worrying about broken pieces or coming back to find your grow room or garden entirely flooded when using high pressure water pumps such as the Submersible AquaKing Pump. All of these PVC parts are super easy to put together, simply make sure to take note of the order in which you should put it together.

How to set up the 25 mm T Connector

• You’ll need to remove one of the heads and remove the pieces from inside – make sure to pay attention to the order and the way the parts are facing.
• You should now have the head, a threaded cone-shaped piece, a plastic washer and a rubber grommet.
• First, place the head on your pipe.
• Next, place the threaded piece without pushing it down too much – it’s hard to pull back up.
• Next goes the plastic washer, and finally the grommet.
• You should have about 1 cm piping (at most) after the washer for the parts to fit properly. You can move the threaded piece until it’s at the desired height.
• Lastly, screw in the head – don’t force it. If it isn’t working, remove it and screw it in again.
• Simply pressing it in with your hand should be good enough to avoid water leakage, although you can press it more using a faucet wrench if you’d like.