LUMii Black Shucko Contactor Timer

LUMii Black Shucko Contactor Timer for Growing Cannabis

The LUMii Black model is a simple yet efficient timer. It’s perfect for programming 4 or 8 lighting systems, depending on the chosen model. It doesn’t need any setting up, helps avoid power surges and can be connecting to any lighting system.

Easy to use Timer

Thanks to the mechanic timer you can easily program the light in your grow room in 15 minute intervals. The best thing about this timer is that it can be used with all lighting systems, even HID lights (High Intensity Discharge) without any power surges which could affect other devices or overheat the timer itself. It has an IP degree of 40, 220-230v voltage, 50Hz frequency and should be used between 25 – 40°C degrees.

The LUMii BLACK model comes in two different versions. The smaller one has four inlets with one mains plug, and the other has eight inlets and two mains plugs. The leads that come with this timer use 13 amps each. For maximum efficiency these are the recommended uses:

• 3 600w Mixed Platinum HPS Bulbs per 4 inlets
• 4 400w HPS Bulbs per 4 inlets
• 4 315w LEC Bulbs per 4 inlets
• 2 630w LEC Bulbs per 4 inlets
• Up to 1800w LED lighting per 4 inlets
• 4 400w HID lights per 4 inlets
• 4 600w HID lights per 4 inlets
• 2 1000w HID lights per 4 inlets

LUMii BLACK Schuko Set Up

To use this device, you’ll need to press the switches on the timer. In order to turn timer mode on, move the white switch towards the clock, indicating that the timing system is on. Connect one or two plug inlet strips, depending on the model, and then connect it all to the mains.

Warning:

Do NOT plug other timers into your LUMii Black Shucko, this could damage the main timer.

Recommendations:

In order to get used to this device we recommend using a small house lamp and timing it; this will make it much easier to familiarize yourself with it before actually using it with your grow room lighting. Don’t move the timer when it’s connected and set up with your lights.